Simple Electronic Circuits For Learning About Circuits

make pcb board prototype at http://www.pcbgogo.com/c

any pcb board quote, pls feel free to contact me via eva@pcbgogo.com

 

Are you starting out in electronics? Then these simple electronic circuits will make it easy for you to start building electronic circuits.

The first time you want to build a circuit, it can be a little bit daunting. “What if my schematic is wrong? What if I did a mistake on the PCB design? What if my Gerber files were not created correctly?”

This way you can choose if you want to start from scratch, start from schematics, start from finished PCB design or just download the Gerber files and get the circuit built.

“Hello World” Circuit

The first of the simple electronic circuits is this little fella. It has a battery holder, a couple ofresistors and six light emitting diodes (LEDs). The reason I call it “Hello World” is because when you turn the power on, the LEDs light up the words “Hello World” written on the PCB layout I have created.

There isn’t much magic going on here, just a battery providing electrical current to some LEDs when you switch it on. But it is a good electronic circuit to start with for the sake of practice. Maybe you can hang it at your desk to remind you of your first professionally built circuit =)

Transistor Blink LED Circuit

This is the solid-state version (no moving parts) of the blinking LED circuit. I think it is the coolest of these simple electronic circuits.

The size of the capacitors C1 and C2 dictates how fast the two LEDs will blink. The resistors R1 and R4 limits the current for the LEDs while R2 and R3 limits the current for the transistor. The BC548 transistor is a NPN transistor which is very, very common and you should be able to find it everywhere they sell electronics parts.

A common mistake when soldering this electronic circuit is to swap R1/R4 with R2/R3. So if you solder this and it doesn’t work, check that you have the resistors in their correct place.

Relay Blink LED Circuit

When I started learning about electronics I had a hard time understanding how to blink a light. My father explained it to me using a relay, a capacitor and a small light bulb.

This circuit is much easier to understand than the blinking LED circuit using transistors.

The relay is powered through its own NC (Normally Closed) switch. The same is the LED. So when the circuit is powered up, the LED will lit up and the capacitor starts charging. When the voltage over the capacitor is high enough, the relay pulls the switch into its NO (Normally Open) position. This means that the capacitor starts discharging and the LED is turned OFF. The voltage starts dropping on the relay coil and when it is low enough, the switch is released into its NC state. And the process is repeated.

 

make pcb board prototype at http://www.pcbgogo.com/c

any pcb board quote, pls feel free to contact me via eva@pcbgogo.com